7
INSTALL THE SERVO TRAY
❍
14. Mix 1/8 oz. (3.5ml) of 6-minute epoxy to glue the servo tray
to the bottom side of the wing. Apply equal amounts of epoxy to the
mounting blocks on both ends of the servo tray. Attach the servo tray
to the bottom of the wing with the notch in the servo tray facing
towards the leading edge of the wing. Allow the epoxy to fully cure
before proceeding to the next step.
APPLY THE WING CENTER SECTION TAPE
❍
15. Starting at the front of the aileron servo tray, apply the 1/2"
(13mm) white wing center section tape completely around the wing
over the joint. A small amount of pressure should be applied to make
a smooth seam.
INSTALL THE AILERON CONTROL HORNS
❍
16. Thread the aileron control horns onto the torque rods until
they are positioned 3/4" (19mm) above the bottom of the wing.
ASSEMBLE THE PUSHRODS
❍
17. Locate two plastic clevises and two 6-3/4" (171mm) aileron
pushrods. Thread the clevises onto the rods so that 1/16" (1.5mm) of
the rod protrudes between the clevis forks.
INSTALL THE PUSHRODS
❍
18. Attach the pushrods to the aileron control horns. If the pins
from the clevises do not fit the holes in the horns, drill the holes out
to 1/16" (1.5mm). Press the forks of the clevises together until the pin
snaps into the opposite fork. Slide the safety tubing into position over
the clevis.
Note: The paper towel in the photo is only there for
photographic purposes. You do not need to install the paper towel
on your aircraft.
This concludes the wing assembly for now. Tape the pushrods to the
wing to keep them in place until the aileron servo is installed.
LOCATE THE WING DOWEL HOLES
❍
1. Locate the four positions for the 1/4" (6mm) wing dowel holes
by gently pressing the covering in the areas in the photos. The
position for the front wing dowels can be seen from the inside of the
fuselage. Carefully cut out the holes using a sharp hobby knife.
Caution: Do not cut out any of the rectangular holes in the sides of
the fuselage.
FUSELAGE ASSEMBLY