24
Collar
M3 x 8
M3 x 5
M3 x 5
Wheel
pant
❏
3. Refer to the image to see which is the right and which
is the left main landing gear (the gear sweeps aft). Using
threadlocker on all the screws, mount the wheels to the axles
with the wheel collars as shown, then fasten the wheel pants
with M3 x 8 Phillips screws.
❏
4. Make sure the wheels are centered in the opening in the
pants and roll smoothly. If necessary, remove the wheel pant
and adjust the location of the wheel on the axle by moving
the wheel collars, then retighten tightly.
❏
5. Mount the landing gear to the fuselage with six M3 x 12
Phillips screws and M3 washers and threadlocker.
Attach the Belly Pan
❏
1. Mount the bottom wing to the fuselage with the included
¼ - 20 x 1" nylon wing bolts and 5/8" x ¾" [16 x 19mm] wing
bolt plates.
❏
2. Carefully cut just into the covering around the wing bolt
plates.
Do
not
cut into the wood.
❏
3. Remove the wing bolts and the wing bolt plates. Remove
the covering from under where the wing bolt plate was.
❏
4. Glue the wing bolt plates to the wing using the wing
bolts to hold them to the wing while the glue hardens.