20
❍
12. Make sure the control surfaces move in the proper
direction as illustrated in the following sketch:
FULL
THROTTLE
RUDDER
MOVES
RIGHT
ELEVATOR
MOVES DOWN
RIGHT AILERON
MOVES UP
LEFT AILERON
MOVES DOWN
4-CHANNEL RADIO SET UP
(STANDARD MODE 2)
❍
13. Install the main landing gear wire using the four nylon
straps and #2 x 3/8" screws. Install the 2-1/2" main wheels
(not included).
❍
14. Install the fuel tank, engine and muffler. Install the
propeller and spinner.
❍
15. Trim the canopy to size. Hold it in position on the fuse,
then draw around its perimeter with a felt-tip pen. Cut away a
narrow strip of covering film, following the line you just drew.
Glue the canopy in position with RC-56 canopy glue or thin CA.
BALANCE YOUR MODEL
NOTE: This section is VERY important and must NOT be
omitted! A model that is not properly balanced will be unstable
and possibly unflyable.
3"
❍
1. Accurately mark the balance point on the
bottom
of the
wing on both sides of the fuselage. The balance point is shown
on the plan (
CG
), and is located
3" (76mm) behind the leading
edge.
This is the balance point at which your model should
balance for your first flights. Later, you may wish to experiment
by shifting the balance up to
1/4" forward or back
to change
Summary of Contents for UPROAR
Page 5: ...5 DIE CUT PAGE ...