Town & Country Fireplaces TC42.NG04D, Installation Instructions Manual

9

TC42_NG04D_091014-16

WARNING

This conversion kit 

shall be installed by a 

qualified service agency 

in accordance with the 

manufacturer's instructions 

and all applicable codes 

and requirements of 

the authority having 

jurisdiction. 

If the information in these 

instructions is not followed 

exactly, a fire, explosion 

or production of carbon 

monoxide may result 

causing property damage, 

personal injury or loss of 

life. 

The qualified service 

agency is responsible for 

the proper installation of 

this kit. 

The installation is not 

proper and complete 

until the operation of the 

converted appliance is 

checked as specified in the 

manufacturer's instructions 

supplied with the kit.

If the unit is to be used on  propane 
 convert as follows using the 
 components supplied with this 
burner:

CAUTION

The gas supply and electrical power 
shall be shut off before proceeding 
with the conversion.

Note:  Factory supplied components must be 

used to ensure correct input.  

After conversion confirm proper manifold 

pressure.

1.  Remove the 2 front screws holding the  

burner tray in place. 
(Fig. #16)

2.  Gently lift up the burner tray while  

sliding to the left to disengage the  
burner tube from the orifice. Then tip  
back to expose the orifice.

3. Using a 1/2” wrench, undo the 

natu ral gas burner orifice. Apply a small 
amount of pipe joint compound to the 
threads of the propane burner orifice 

to ensure a good seal,  before screwing 
it into the fitting. Loosen the primary air 
shutter screw,      

open shutter fully and 

re-tighten. 
(Fig. #17)

4.  

Remove the 2 screws 
holding the pilot assembly in place with 
a stubby screwdriver. 
(Fig #18)

The burner assembly must 
be removed from the unit if 
previously installed.

Propane Conversion

Fig #16

Fig #17

Fig #18

CONVERSION LABEL (5052.5206D)

MAIN BURNER  (2.50 mm)
ORIFICE  (5022.3)