TC54_NG02D_060317-20
1. Place the contents of one bag of ember material onto the surface of the lower burner (Figure 20).
Be sure to place enough ember material onto the front and back burner tubes so that the holes in
the tubes are no longer visible.
2. Locate the first log positioning pins on the log grate (Figure 21).
3. The underside of the first log has a square slot at the right side, and a round hole at the left side.
Position the right side of the log (with the square slot) onto its positioning pin. Then finish by plac-
ing the left side of the log (with the round hole) onto its positioning pin. Once the first log is in
place it will hide the upper burner (Figure 22).
Figure 20: Ember material on lower burner.
Figure 21: First log positioning pins.
Figure 22: First log placement.
Figure 23: Second log positioning pins.
4. Locate the positioning pins for the second log placement. The pin for the lower end of the sec-
ond log is located on the left side of the log grate. the upper pin for the second log placement is
located on the left hand - upper side of the first log (Figure 23).
8
5056.4256202D
