TCWS.54NGST04D_120517-20
NOTE: Check air shutter for correct fuel setting before proceeding any further. Both burner
shutters are to be set the same. Fully closed for NATURAL GAS and 3/16” open for LIQUID PROPANE.
CAUTION: The burners should be tightly butted up against each other at the center to ensure
correct operation.
3/16” Open for Propane Gas
Fully closed for Natural Gas
Figure 8: Shutter gap settings.
7. Check to see that the air shutters on the burners are set to the gas type being used before installing the
burners (Figure 8).
8. The left hand burner has a tab on its underside. This tab will fit into the slot located on the top of the
center leg (Figure 9).
9. While lining up the tab and the slot, fit the air shutter over the orifice. Lay the burner down onto the center
leg and the outside left leg. Move the burner toward the center of the fireplace until the tab reaches its
end in the slot (Figure 10).
10. Install the right hand burner by laying it down on the center leg and the outside right leg.
Slot
Tab
Figure 9: Installing left hand burner tab to center leg.
Burner tab
Orifice
Air shutter
Figure 10: Installing left hand burner air shutter onto
orifice.
5
5056.425183D
