Operating procedure
Initializing the System for the first time
Install the 3 AAA type batteries in the Transmitter battery bay, located on the base of
the Transmitter (fig.6
1
).
Power on the wall switch/receiver. To activate the receiver address programming,
see " Linking the remote control unit to the wall switch" section on page 15 of this manual.
Fig. 6
1
:
B
a
ttery compartment.
Temperature indication Display
With the system in the “OFF” position, press the Thermostat Key and the Mode
Key at the same time. Look at the LCD screen on the Transmitter to verify that a C
or F is visible to the right of the Room Temperature display. (Fig. 6
2
and fig. 6
3
)
Fig. 6
2
: Remote Control display in Fahrenheit. Fig. 6
3
: Remote Control display in Celsius.
Turn on the Appliance
With the system OFF, press the ON/OFF Key on the
Transmitter. The Transmitter display will show some
other active Icons on the screen. At the same time the
Receiver will activate the appliance. A single “beep”
from the Receiver will confirm reception of the
command.
Turn off the Appliance
With the system ON, press the ON/OFF Key on
the Transmitter. The Transmitter LCD display will
only show the room temperature (Fig. 6
4
). At
the same time the Receiver will turn off the
Appliance. A single “beep” from
the Receiver
confirms reception of the command.
Fig. 6
4
: Remote Control display
37
TCWS38_D 011214-48
Summary of Contents for TCWS38
Page 43: ...Fig 76 Wiring Diagram 43 TCWS38_D 011214 48 ...
Page 45: ...45 TCWS38_D 011214 48 ...
Page 46: ...46 TCWS38_D 011214 48 ...
Page 47: ......
