The standoffs are shipped loose
inside the fireplace and must be
installed on the top and the side of
the fireplace as shown in Fig. #8.
Do this once the fireplace is on
site and in position.
In planning the installation for the fireplace, it is necessary to determine where the unit is to
be installed, location of vent system and where gas supply piping may be plumbed. Various
installations are possible, such as, into an existing wall, a corner, a built-in wall or a wall
projection (Fig. #9). Due to high temperatures, do not locate this fireplace in areas of high
traffic or near furniture or draperies.
The minimum clearances from the fireplace to combustible surfaces must be adhered
to and are shown in Fig. #2 and Fig. #3.
EXAMPLES OF COMMON LOCATIONS
SEE FIG #13 FOR DIMENSIONS
HANDLE
CONTROL
BOX
TOP STANDOFFS
Fig. #8
Fig. #9
7
TCWS38_D 011214-48
Locating The Fireplace
Standoffs
Summary of Contents for TCWS38
Page 43: ...Fig 76 Wiring Diagram 43 TCWS38_D 011214 48 ...
Page 45: ...45 TCWS38_D 011214 48 ...
Page 46: ...46 TCWS38_D 011214 48 ...
Page 47: ......