5056.425217-A
Figure 5: Wall switch.
Using the Remote Control Transmitter
Temperature indication Display
With the remote control transmitter in the “OFF” position, press the thermostat
and mode keys at the same time. Look at the LCD screen on the remote control
transmitter to verify that a C or F is visible to the right of the room temperature
display - Figure 7 and Figure 8.
Turn on the Fireplace
With the fi replace OFF, press the ON/OFF key on the remote control transmitter.
The remote control transmitter display will show the active icons on the screen.
At the same time the wall switch will activate the fi replace via the IFC module. A
single “beep” from the IFC module will confi rm reception of the command.
Figure 3: Wall switch - interface
side.
Program button
Turn off the Fireplace
With the fi replace ON, press the ON/OFF key on the remote control transmitter. The remote control transmit-
ter LCD display will only show the room temperature (Figure 7 and Figure 8). At the same time the IFC module
will turn off the fi replace. A single “beep” from the IFC module confi rms reception of the command.
Manual Bypass of the Remote Fireplace
If the batteries of the remote control transmitter are low or depleted, the fi replace can be turned off manually
using ON/OFF switch located on Town & Country wall switch. This will bypass the remote control transmitter.
Figure 4: Wall switch with no
batteries.
Figure 6: Profl ame 2 remote
battery compartment.
Figure 7: Temperature in
fahrenheit.
°
C
Figure 8: Temperature in
celcius.
8
TCWS54DST_
160517-16
