PAINT:
The vent terminal comes pre-painted
with Thurmalox 230 Series paint by
Dampney Co., but can be painted to
match your wall fi nish color using
high temperature paint that can
withstand temperatures of at least 250
degrees fahrenheit or 120 degrees
Celcius.
Ensure the your paint is compatible
with Thurmalox 230 Series paint.
16 1/8”
16 11/16”
8 3/4”
7 7/8”
6 11/16”
14 11/16”
1 5/16”
Terminal Dimensions
This kit uses either Simpson Duravent GS direct vent pipe, Secure Vent
direct vent pipe, Selkirk Direct-temp vent pipe or ICC Exceldirect vent pipe
with a 5” inner pipe and an 8” outer pipe. For part numbers see the table of
venting components on page 19 of this manual. This vent can only be used
as a side wall termination.
1. Locate the power vent termination following the clearance to combustible table(Page 20
$ page 21), venting confi guration diagram (Fig. #41 & 27), and terminal location diagram
(Fig. #28).
2. Cut and frame a 14 1/2” wide by 14 3/4” high opening. For standard up and out
installations, the opening should be 3/4” lower than the minimum specifi ed in Fig. #27.
Height of the opening will vary with each installation. See Fig. #29.
3. Attach the power vent terminal, by securing the outer fl anges on the perimeter of the
terminal to the outside wall; ensure that the terminal is the right way up (exhaust at the
bottom). Once secured to the building, the outer fl anges may be covered with siding/
stucco/etc. up to the level of the perimeter edge. As per local building codes. See Fig. #30.
4. For wall thicknesses 7 1/2” or less, install the inner wall plate supplied over the terminal
as shown in Fig#31 and secure to the framing. See Fig. #31.
CAUTION:
This terminal is designed to be
fi nished fl ush to the fi nished outside
wall; under no circumstances
should this terminal be recessed
into the wall past this point.
(Fig. #30)
Horizontal (Side Wall) Venting
CAUTION:
The rise and run combination and the
number of elbows must not exceed
specifi cations in Fig #41.
28
TCWS.54CSTE 110712-72
Summary of Contents for TCWS54ST SERIES D
Page 70: ...70 TCWS 54CSTE 110712 72 ...
