Installation:
If conver ting to propane see
conversion instructions on page #43
before proceeding.
1.
Install the secondary fl oor on the side
away from the gas connections fi rst.
2. Inser t the wires leading from the
secondary fl oor half through one of the
grommets in the bulkhead plate.
3. On the bulkhead side, tilt the fl oor
approximately 45 degrees and insert the
wires from the fl oor through the rubber
grommet in the bulkhead plate (Fig. #91).
4. Insert the pilot up through the pilot hole
then lower and secure the secondary
fl oor half in place(Fig. #91).
5. Place the first burner as shown in
(Fig.#92). Be sure to engage the venturi
fully onto the orifi ce. Secure with single
screw in burner support leg. Repeat with
other burner.
NOTE: Check air shutter for correct
fuel setting before proceeding
further. Both burner shutters are
to be set the same, fully closed for
natural gas. 13/64 (0.2)” open for
LP.
CAUTION: The burners should be tightly
butted up against each other at the
center to ensure correct operation.
6. Attach the pilot to the burner support leg
as shown in Fig. #93.
SCREW
PILOT HOLE
GROMMETS
Fig #92
Fig #93
Fig #91
48
TCWS.54CSTE 110712-72
Summary of Contents for TCWS54ST SERIES D
Page 70: ...70 TCWS 54CSTE 110712 72 ...
