Town & Country Fireplaces TCWS54ST SERIES D, Installation And Operating Instructions Manual

LIGHTING INSTRUCTIONS

1.  STOP! Read the safety information above on this label.
2.  Set wall switch/ hand held remote to lowest setting.
3.  This appliance is equipped with an ignition device which 

automatically lights the pilot. Do not try to light the pilot by 
hand.

4.  Push the "On/ Off" switch to the fi replace Off.
5. Allow 

suffi cient length of time (minimum 5 minutes) for any 

gas in the combustion chamber to escape. If you still smell 
gas, STOP! Follow "B" in the safety information above on 
this label. If you don't smell gas, go to the next step.

WARNING: If you do not follow these instructions 

exactly, a fi re or explosion may result causing 

property damage, personal injury or loss of life.

A.  This appliance is equipped with an ignition device which auto-

matically lights the pilot. Do not try to light the pilot by hand.

B.  BEFORE LIGHTING smell all around the appliance area for gas. 

Be sure to smell next to the fl oor because some gas is heavier 
than air and will settle on the fl oor.

WHAT TO DO IF YOU SMELL GAS:

- Do not try to light any appliance.

- Do not touch any electric switch; do not use any phone in your 
building.

FOR YOUR SAFETY READ BEFORE LIGHTING

6.  Push the "On/ Off" switch to turn the fi replace ON.
 

- If the burner does not light, repeat steps 4 through 6.

- If the burner will not light or stay lit after several tries, 
push the "On/ Off" switch to the fi replace OFF, set the ther-
mostat to the lowest setting, turn off all electric power to the 
fi replace and call your service techinician or gas supplier.

 Note: 

Suffi cient time must be allowed for air to escape from 

lines if the unit is being lit for the fi rst time.

7. Set 

fi replace to desired setting by using either the wall 

switch or hand held remote.

- Immediately call your gas supplier from a neighbour's phone. 
Follow the gas supplier's instructions.

- If you cannot reach your gas supplier, call the fi re department.

C. Use only your hand to push in or turn the gas control knob. 

Never use tools. If the knob will not push in or turn by hand, 
don't try to repair it, call a qualifi ed service technician. Force or 
attempted repair may result in a fi re or explosion.

D. Do not use this appliance if any part has been under water. 

Immediately call a qualifi ed service technician to inspect the 
appliance & to replace any part of the control system & any gas 
control which has been under water. 

180612

5051.175

5-TCWS54ST

         Hot while in operation. Do not touch. Severe burns may result. Keep children, clothing, 

furniture, gasoline and other liquids having fl ammable vapours away. Keep burner and control compartment 
clean. See installation and operating instructions accompanying the appliance.

CAUTION

:

   L'appareil est chaud lorsqu'il fonctionne. Ne pas toucher l'appareil. Risque de brûlures 

graves. Serveiller les enfants. Garder les vêtements, le meubles, l'essence ou autres liquides produisant 
des vapeurs infl ammables loin de l'appareil. S'assurer que le brûleur et le compartiment des commandes 
sont propres. Voir les instructions d'installation et d'utilisation qui accompagnent l'appareil.

ATTENTION

:

TO TURN OFF GAS TO APPLIANCE

1.  Set wall switch / hand held remote to lowest setting.
2.  Push the "on/ off" switch to the "Off" position.

3.  Turn off all electric power to the appliance and remove 

backup batteries if service is to be performed or for extended 
shutdown.

Due to high surface temperatures, keep children, clothing and furniture away. Keep burner and control compartment clean. See 
installation and operating instructions accompanying the appliance.

A cause de la temperature elevee des parios, tenir eloignes les enfants, les vetements et les meubles. Maintenir propres le 
bruleur et le compartiment de commande. Voir les instructions relatives a l'installation et au fonctionnement qui accompagnent 
l'appareil.

When lit for the fi rst time, the fi replace will emit a slight odour for a couple of hours. This 
is due to the curing of paints, sealants and lubricants used in the manufacturing process. 
This condition is temporary. Open doors and windows to ventilate area. Odour caused by 
the curing process may cause discomfort to some individuals.

It is normal for fi replaces fabricated of steel to give off some expansion and/or contraction 
noises during the start up or cool down cycle. Similar noises are found with your furnace 
heat exchanger or cook stove oven.

55

TCWS.54CSTE 110712-72

Lighting Instructions

First Fire