Program Mode
(To preset up to two on and off periods per
day)
The program mode has two settings for
weekdays and two for weekends. The hand
held remote comes with the following pre
programmed settings:
Weekday Program
(Monday through Friday)
Program one (P1) turns ON at 7:00am and
turns OFF at 8:00am
Program two (P2) turns ON at 5:00pm and
turns OFF at 7:00pm
Weekend Program
(Saturday and Sunday)
Program one (P1) turns ON at 9:00am and
turns OFF at 10:00am
Program two (P2) turns ON at 6:00pm and
turns OFF at 9:00pm
Activate the programs by pressing the program
button on the lower left hand side of the remote
hand set. (Fig. #113)
To customize these settings:
1.
Hold the program button down until the
display fl ashes. (P1, weekday ON time -
[Fig. #114])
2.
Use the up and down buttons to change
the time to the desired ON time.
3.
By pressing the OK button, the P1 weekday
OFF time will fl ash. (Fig. #114)
4.
Use the up and down buttons to set the
desired OFF time.
5.
Press the OK button and the P2 weekday
ON time will fl ash.
6.
Repeat the process to set the P2 weekday,
P1 weekend and P2 weekend programs.
7.
When the P2 OFF time is set and the OK
button is pressed the display will stop
fl ashing and the remote will be in program
mode.
The program settings are now stored in the remote handset and will not change unless the
above process is repeated or the batteries are removed from the handset.
To switch out of program mode, simply press one of the manual, timer or thermostat mode
buttons. Please note that if the manual button is pressed it will turn the fi replace off.
Fig. #111
TIMER
Fig. #112
TIMER
RUN
DISPLAY
PROGRAM
Fig. #114
Fig. #113
58
TCWS.54CSTE 110712-72
Summary of Contents for TCWS54ST SERIES D
Page 70: ...70 TCWS 54CSTE 110712 72 ...
