12
Town Food Service Equipment Company, Inc.
718/388-5650 outside New York State 800/221-5032
n
If equipment requires service, contact your authorized gas service company to perform necessary repairs.
n
Check the flue riser monthly to be sure it is free of obstructions. Be sure to clean the air mixers and orifices
of ring burners once a year. Jet and shield tip burners must be serviced more often as they become clogged
more easily. This service must be performed by a qualified gas service company.
n
Range should be cleaned each evening with grease dissolver and rinsed well. It will prevent grease
accumulation and keep the unit clean and sanitary.
n
If unit is supplied with casters, there should be a restraint on the appliance to limit its movement.
If disconnection of the restraint becomes necessary, it is imperative that the restraint be reconnected after the
appliance is returned to its originally installed position.
THE FOllOWING SERVICE SHOuld BE dONE ONlY BY a QualIFIEd GaS SERVICE TECHNICIaN
CHaNGING THE PIlOT lIGHT IN a CHaMBER WITH a RING BuRNER OR SHIEld TIP BuRNER
Shut off pilot valve. The pilot light is mounted on flexible tubing and can be raised. Using a 12mm open-ended
wrench, hold the center of the compression fitting below the pilot firm.
Using a
1
/
2
”
wrench, unscrew the pilot from its brass fitting at bottom. Install the new pilot by reversing the above
procedure. Adjust the pilot flame at the pilot valve and be sure to check for gas leaks using a soapy solution.
CHaNGING THE PIlOT lIGHT IN a CHaMBER WITH a JET BuRNER
Shut off pilot valve. Using a 12mm open-ended wrench, unscrew the pilot, remove and replace.
If a 12mm open-ended wrench is unavailable, a
1
/
2
”
open end or adjustable wrench may suffice.
FluE COllaR REPlaCEMENT (
“
F
”
MOdElS)
The cast iron flue collar may deteriorate after considerable use. If deterioration is detected, we suggest you
contact your local service company for replacement parts and qualified service. If you must replace the flue col
-
lar yourself, follow the instructions below:
SHuT OFF GaS TO RaNGE BEFORE MakING aNY adJuSTMENTS
THE BuRNER aNd PIlOT MuST BE REMOVEd BEFORE REMOVING THE FluE COllaR
1) Remove old nuts behind range that secure flue collar (1).
2) Remove worn collars with pry bar (2).
3) Put new collar into place using provided hardware.
4) Re-cement chamber and replace burner and pilot.
PILOT VALVE
PILOT
FLUE COLLAR
ON position
turn clockwise
until screw
cannot be turned
OFF position
turn counter-clockwise
pilot screw
12
MaINTENaNCE aNd CaRE
_________________________________________________________________________________
