YW2012
11
Next Free User Code ID Locator
Key Sequence
[#] [Master Code or Manager Code
] ● [10] ●●
If a free user ID is recognized, the following sequence will occur:
At the start of the Next Free User ID Location function, the lock will flash both the green and red LED and emit 2 beeps.
The keypad will light the 2-digit User ID, one digit at a time, showing the next free user ID available for use.
To signify the end of the Next Free User ID, the lock will flash both the green and red LED and emit 2 beeps.
If no free address is found, then the lock will emit one long beep (0.5 sec) with a red LED.
Reset to Factory Default Settings
Reset to Factor Default Settings with a Master Code
Key Sequence
[#]
[Master Code] ● [99] ● [99] ●●
Reset to Factor Default Settings without a Master Code
1. Remove one battery.
2.
Press and hold the “0” button, then replace the battery.
3.
Release the “0” button after green LED flashes twice and lock beeps twice.
4. Within 3 seconds, press the star (
✴
) key 3 times.
The green LED will light for 7 seconds and 2 beeps will sound.
The lock is reset to the Factory Default Settings. All programming is deleted. Master Code is 12345.
Low Battery Warning
When the battery voltage is low, the red LED will flash 5 times before the green LED flashes to signal acceptance of the code.
Batteries should be changed as soon as this happens. Only 200 operations are allowed under low battery condition. After 200
operations, User Codes will be disabled under low battery condition. Then, only Master Code can be used to unlock the lock,
and LED indicator will flash red 10 times before the lock is unlocked.
Summary of Contents for e-Elite 3000
Page 1: ...YW2012 XCE and XME 2000 Series Locks ...
Page 13: ...YW2012 12 ...