YW1949
10
The Factory Default Setting is set to one credential.
Dual Verification Mode and Passage Mode cannot be programmed simultaneously.
Adjust Keypad Sound
Key Sequence
Notes
Disabling the sound only affects general operation, not during programming of the lock.
During programming mode, lock will temporarily re-enable sound.
Reset Lock to Factory Default Settings
without a Master Code
Steps
1.
Unscrew the back cover.
2.
Locate the reset button on the battery holder.
3.
Press and hold the reset button. After approximately 4
seconds,
the lock will beep 2 times and you can release the reset button.
4.
The
green
LED indicator will light up and it will beep 1 time indicating lock is reset.
Result
Lock is reset to Factory Default Settings.
All codes are deleted and Master Code changes to 123456.
Summary of Contents for e-Secure 5000 RF Series
Page 1: ......