TownSteel e-Secure 5000 RF Series, Programming Manual

YW1949 

4 

Definitions



Credential: 

The lock requires a valid credential to operate. A credential can be a 6-10 digit Master Code, User Code, or 

Keycard/Fob.  



LED Indicator: 

The LED indicators are located around the keypad of the lock. Lock flashes 

green

 LED and/or 

red

 LED 

dependent on inputs. While unlocking, a 

red

 LED followed by a 

green

 LED means the lock is not programmed and can 

be unlocked with any 6-10 digit code or Keycard/Fobs.  



i



Master Code:

 The Master Code programs all User Codes, Keycards/Fobs (Credentials), and System Settings. The 

Factory Default Setting’s Master Code is 123456. This must be changed before programming the lock. Each lock has 

one Master Code. Master Code cannot be deleted. 



i



User Code: 

User Codes are used to operate the lock. User Codes are programmed by the Master Code. The lock can 

have a maximum of 400 User Codes (interchangeable with Keycards/Fobs).  



i



User Keycard/Fob:

 Keycards or Fobs can be used to operate the lock. Master Code is used to program User 

Keycards/Fobs. Swipe the touch keypad with a Keycard/Fob to operate the lock. The lock can have a maximum of 400 

Keycards/Fobs (interchangeable with User Codes). Any standard Keycard/Fob can be programmed into the lock. 



i



Passage Mode: 

When a passage credential is entered the

lock will remain actively unlocked until the Master Code or the 

Passage Credential is re-entered. 



i



Dual Verification Mode:

 Two valid credentials are needed to unlock the door. 



i



Sound:

 Keypad sound is enabled by Factory Default Settings. Disabling the sound only affects general operation, not 

during programming of the lock. During programming, lock will temporarily re-enable sound. 

Factory Default Settings

Master Code: 

123456 

Penalty Time: 

1 minute 30 seconds after 5 invalid entries 

Passage Mode:

 Disabled

Dual Verification Mode: 

Disabled 

Sound:

 Enabled