拓陽精密科技
18
needle during use, it is recommended that the main needle be adjusted to
3 laps
and the auxiliary
needle to
3.5 laps
. Since the methanol engine needs to keep the filament temperature of the
electric plug in order to realize ignition, when the engine is in the oil-rich state for a long time at
low speed, the filament temperature will gradually decrease, resulting in ignition difficulties, so it
is necessary to pull high speed oil at intervals to avoid oil-rich at low speed
Since the four-cylinder four-stroke engine requires a large amount of air intake, it is very important to set
the throttle upsetting wire, so that the minimum throttle opening (idle speed setting) is about
2.5mm.
Because the throttle upsetting wire is designed to be self-locking mode for all kinds of engine
enthusiasts, it is not necessary to twist the throttle upsetting wire to adjust the size of the throttle
opening, but to relax the throttle upsetting wire. Wire, then pull the valve rocker arm to adjust. As shown
in the figure:
Summary of Contents for FS-V400A
