User Instructions for Model TY-R-2400, TY-T4 and TY-S-2400
Battery Installation
1.
Remove the remote control and battery from the poly bag.
2.
Open the battery cover on the back of the remote by sliding the cover towards the bottom of the
remote
3.
Clean the battery contacts and also those of the device prior to battery installation.
4.
Use only 12V Alkaline battery type 23A for replacement, use of other batteries may damage remote.
5.
Insert negative (-) end of the battery (see marking on battery) into the spring side of the battery
holder and insert positive (+) end of the battery into other side.
6.
Close battery cover by sliding back into place.
Remote Control Operation:
The remote has three buttons on the front side to operate the controller with 2422MHz receiver and
conneced light set:
a.
ON/OFF – this is the upper button. Press to turn the set OFF. Press again to turn the set ON.
Note: even when the lights are off, the set still has power to all lamps, to disconnect power,
you must unplug the set.
b.
FUNCTION – this is the second button. Press to change the light pattern to the next function
mode. After reaching last function, the set can be returned to Function 1 by pressing the
function button again. For best results, pause for a few seconds before pushing the
“FUNCTION” button again for the next function.
c.
DIMMER – this is the third button. Press to change the brighteness of a certain lighting pattern.
d.
SENSOR – this is a lowest button. Press to change the controller working under “ Sensor
“ Mode.
Controller Installation:
FOR WALL MOUNTING
Fasten the screws(pre-attached in the upper section of enclosure) and hook the unit to a wall ; Make
sure the unit fits securely against the wall.
FOR GROUND STAKIING
Slide the ground stake into the slot on the base of the unit.Carefully press the stake into the ground.
Plug your Christmas light strings or decorative lighting outfits into the outlets of main controllers TY-T4 and
satellite
controller TY-S-2400 (MAX 420 Watts total).
Plug the main power cord into a power outlet (recommended to plug into a receptacle or extended
receptacle protected by GFCI).
Features:
Remote Control Functions
a) Regular mode
16 Pre-programmed Settings ( Note: The sequence of Settings may be veried) , the default setting when
powered is steady on;
1.
Combination Light Show (Cycles through functions)
2.
Fast Chasing right to left from one light set to the other
+
-
