103
5.4.5.
Analog Output (2) and (3) Gain and Offset Adjustment
The sections {5.4.4.} and {5.4.5.} describe how to adjust analog input/output gain and offset automatically
with area S parameters.
Analog output (2) and (3) adjustment
●
Analog output (2) and (3) require an optional board such as <IO66-Z>.
When these optional boards are not used, the settings and adjustment described below are not required.
This section describes the procedures for changing the gain and offset of analog output (2) and (3), with the
following example of the analog output (2) gain and offset: L-03 and L-04 when <IO66-Z> is used.
Be sure to do this after adjusting offset and gain of the analog input (2).
Use the analog output (2) characteristics selection: L-01 and the analog output (2) adjustment: S-06 parameters.
For details of the analog input (2) characteristics selection and analog output (2) characteristics selection,
refer to {5.3.10. Area L}. For details of the analog output (2) adjustment, refer to {5.3.14. Area S}. For details
of how to change parameter settings, refer to {4.2.3. Changing Parameter Settings}.
Analog Output (3) Gain and Offset Adjustment
●
For analog output (3) gain and offset, refer to the area L.
●
Specify setting items of the area L and area S to meet the analog output (3) gain and offset. Then, follow
the procedures below.
