106
16. Press the [SET] key.
･
"0" is displayed on the extreme right, and the underscore blinks
on the extreme left.
17. Press the [
→
] key to blink required digits, and then press
the keys [
↑
] or [
↓
] to specify numbers to become "1040."
18. Press the [SET] key.
･
The password input is confirmed, and the screen returns to
"S-06" display.
･
When a different number from "1040" is input, "P-Err" indicating
an error is displayed. In this case, press the keys [
↑
] or [
↓
]
to return to "S-06."
Follow the procedures again from the step 16.
Display indicating a password error
19. Press the [SET] key.
･
"0" is displayed on the extreme right, and the underscore blinks
on the extreme left.
20. Press the [
→
] key to blink a required digit, and then press the keys [
↑
] or [
↓
] to change the number
to "1" (Analog output (2) offset adjustment).
･
The display of the setting value automatically returns to that
of the setting item in ten seconds. Unless a setting value is
specified while it is displayed, it cannot be changed.
21. Press the [SET] key.
･
The change is confirmed, and "S-06" is displayed again.
･
The display of the setting value automatically returns to that
of the setting item in ten seconds. Unless the [SET] key is
pressed while a setting value is displayed, it is not confirmed.
22. Press the [
→
], [
↑
] or [
↓
] keys to specify "L-01."
