141
6. Press the keys [
↑
] or [
↓
] to display "S-00."
･
When the first item of the basic setting area is displayed, press
the [
↓
] key once to display "S-00."
･
For details of the special mode selection: S-00, refer to
{5.3.14. Area S}.
7. Press the [SET] key.
･
On the extreme right, "0" is displayed.
･
The underscore blinks on the extreme left, which indicates that
this becomes the operating digit.
8. Press the [
→
] key to blink required digits, and then press the keys [
↑
] or [
↓
] to specify "1040."
･
"1040" is a password. It is required to use the
Special_mode_selection "S-00".
9. Press the [SET] key.
･
The password input is confirmed, and the screen returns to
"S-00" display.
･
When a different number from "1040" is input, "P-Err" indicating
an error is displayed. In this case, press the keys [
↑
] or [
↓
]
to return to "S-00." Follow the procedures again from the step
7.
･
Here, you can stop the initialization by pressing the
[STOP/RESET] key.
Display indicating a password error
10. Press the [SET] key.
･
Again, "0" is displayed on the extreme right, and the underscore
blinks on the extreme left.
11. Press the [
→
] key to blink a required digit, and then press the keys [
↑
] or [
↓
] to change the number
to "1" (Initialize the converter).
･
The display of the setting value automatically returns to that
of the setting item in ten seconds. Unless a setting value is
specified while it is displayed, it cannot be changed.
･
The change is confirmed, and then a message of "rEturn to FActory
SEttinG" is displayed in turn.
･
Then, "SurE" blinks.
･
Here, you can stop the initialization by pressing the
[STOP/RESET] key.
