32
4.2.
Basic Operating Procedures from Console
4.2.1.
Explanation of Display and Operation Keys on Console
On the console of the converter, you can operate it, read and write each function setting data, display operating
states, and display what are protected during protection operations.
The console consists of the components listed below: displays 1 through 3 and operation keys 4.
1: Seven-segment display
2: Unit LED
3: Status display LED
･
FNC: Turns on when the FNC mode (function setting mode) is selected.
･
DIR: Turns on when the [START]/[STOP] key on the console panel is enabled.
･
REV: Turns on when the power supply wiring is reverse phase.
･
REG: Turns on while the converter performs regenerative operation.
･
RUN: Turns on while the converter is running.
･
PWM: Turns on when the converter selects the PWM sine wave mode.
4: Status display LED supplementary information (This does not turn on. Supplementary information for MODE LED.)
5: Operation keys
Converter operation
●
In addition to using the console described below, you can operate the converter and set various functions in the following
ways:
･
External console option <SET66R-Z>
･
Contact input and analog input
･
Control through external digital communication
･
Internal PLC function
●
Sometimes you cannot operate the converter from the console, depending on settings.
1
3
2
4
