37
◆
Notes for each operation key
･
[MONI/FNC] key
Switches the monitor (MONI) mode to the function setting (FNC) mode and vice versa.
The current mode is indicated by the [FNC] LED on or off.
･
[START] and [STOP/RESET] keys
Only when you can operate the converter from the console, you can use these operation keys.
When you can operate it from the console, the [DIR] LED turns on.
･
[
↑
] and [
↓
] keys
Each time you press these keys, the display changes one by one. Also, when you press and hold them, the display
changes continuously.
■
Basic operating procedures for keys
(1) To move the operating digit
When you change various settings in the function setting (FNC) mode, a blinking digit of alphanumeric
characters indicates the operating digit.
You can shift the operating digit to the right by pressing the [
→
] key. Shifting to the left is possible
only when setting a parameter using the [
←
] key. If you press the [
→
] key while the operating digit is
in the right edge of the seven-segment display, it moves to the leftmost digit or the maximum settable digit.
Likewise, if you press the [
←
] key while the operating digit is in the left edge of the seven-segment display
or the maximum settable digit, it moves to the rightmost digit.
(2) To change numerical values
How to set a negative value in the seven-segment display on the console
Use the [
→
] or [
←
] key to move the operating digit to the leftmost one and then use the key [
↑
] or [
↓
]
to change a number.
･
By pressing the [
↑
] key
A number changes in the following order: "0" -> "1" -> "2"
･･････
"8" -> "9" -> "-." After "9," a negative
value is displayed.
･
By pressing the [
↓
] key
A number changes in the following order: "0" -> "-" -> "9"
･･････
"3" -> "2" -> "1." After "0," a negative
value is displayed.
