39
4.2.3.
Changing Parameter Settings
This section provides the basic operating procedures for checking and changing parameter settings required to
operate the converter on the console.
･
Set the console to the function setting (FNC) mode.
･
Some parameters can be changed while the converter is running.
For details, refer to {5.3. Detailed Explanation of Each Parameter}.
■
How to check parameter setting values
To check parameter settings of the converter, perform the following steps on the console:
For example, this section provides procedures to display a setting value of the parameter d-18 of the area d.
1. When the [FNC] LED on the console is off, press the [MONI/FNC]
key.
･
The [FNC] LED turns on, and the console enters the function
setting (FNC) mode.
･
A setting item appears in the seven-segment display on the
console.
For example, immediately after the converter is turned on, the
first item of the basic setting area is displayed.
DC voltage command: 0.VrEF
2. Press the keys [
↑
] or [
↓
] to display the first setting item "d-00" of the area d.
･
The alphabet character "d" in the setting item blinks, which
indicates the operating digit.
3. Press the [
→
] key once to blink "0" in the tens digit, and
then press the keys [
↑
] or [
↓
] to change it to "1."
･
As a result, "d-10" is displayed.
