52
5.2.
List of Parameters
The table below lists the seven-segment displays and corresponding setting items on the console in setting
parameters.
Some setting items are not used when the 120-degree conduction mode is selected. The items having
〇
in the
"Used in 120-degree conduction mode" column are used in the 120-degree conduction mode. The items having
x are not used in the 120-degree conduction mode.
For details of each parameter, refer to {5.3. Detailed Explanation of Each Parameter}.
Basic setting area
Display
Contents
Used in
120-degree
conduction mode
0.VrEF
DC voltage command while selecting the DC voltage command fixed mode
* Enabled when the DC voltage command fixed mode selection: <d-00> is set to
ON in the PWM sine wave mode.
x
1.PHi
Power-factor angle
x
2.FrEq
Power supply frequency
x
Area A (filter constant setting area)
Display
Contents
Used in
120-degree
conduction mode
A-00
AC reactor constant (1 phase)
x
A-01
Capacitance of filter capacitor (1 phase of phase conversion)
x
Area b (operation command related setting area)
Display
Contents
Used in
120-degree
conduction mode
b-00
Setting data rewrite protection
○
b-01
PLCL function enable
○
b-02
PLCH function enable
○
b-03
Operation command source selection
○
b-04
DC voltage command source selection
x
b-05
Active current command source selection
x
b-06
Reactive current command source selection
x
b-07
Selection of restart after instantaneous power interruption
○
b-08
For special adjustment
*
○
* This is for special adjustment only. Do not use it usually.
