92
6. Press the [SET] key.
･
The password input is confirmed, and the screen returns to
"S-00" display.
･
When a different number from "1040" is input, "P-Err" indicating
an error is displayed.
In this case, press the keys [
↑
] or [
↓
] to return to "S-00."
Follow the procedures again from the step 4.
Display indicating a password error
7. Press the [SET] key.
･
Again, "0" is displayed on the extreme right, and the underscore
blinks on the extreme left.
8. Press the [
→
] key to blink a required digit, and then press the keys [
↑
] or [
↓
] to change the number
to "103."
･
The display of the setting value automatically returns to that
of the setting item in ten seconds. Unless a setting value is
specified while it is displayed, it cannot be changed.
9. Press the [SET] key.
･
The display of the setting value automatically returns to that
of the setting item in ten seconds. Unless the [SET] key is
pressed while a setting value is displayed, it is not confirmed.
･
The change is confirmed, and "StoV2" and "SurE" blink
alternately.
↓↑
10. Press the [SET] key.
･
The setting is confirmed, and "StoV2" is displayed.
Data is being transferred
･
When the version of the converter main unit is different from
the software version number of <SET66R-Z>, "VErr" blinks.
･
Press the [STOP/RESET] key to interrupt copying data. Press the
[SET] key to continue to copy data.
･
Data is transferred from the converter main unit to <SET66R-Z>.
When it has been completed successfully, "End" is displayed.
･
When communication between the main unit and <SET66EX-Z> is
disconnected during transfer, transfer is interrupted.
(1) Interrupted with the setting block displayed
(2) Interrupted ten seconds after blinking "rErr"
In either case, the setting block is displayed after
interruption and then the monitor item display returns. Perform
again the procedures from the first step.
Data transfer has been completed
Error indication
･
Five seconds later, the converter series name is displayed, and
then contents similar to what are displayed at power-on are
displayed. Refer to {4.1.2. What Are Displayed at Power-on}.
