P12477
Seal Packing
A85937
Upper
Front
60
_
A09519
8 mm
Hexagon
Wrench
A09476
Seal Width
2 to 4 mm
(0.08 to 0.16 in.)
−
ENGINE MECHANICAL
PARTIAL ENGINE ASSY (1CD
−
FTV)(From September,
2003)
14
−
11
1CD
−
FTV ENGINE REPAIR MANUAL (RM1046E)
33.
INSTALL CYLINDER BLOCK WATER DRAIN COCK
SUB
−
ASSY
(a)
Apply seal packing to the 2 or 3 threads.
Seal packing: Part No. 08826
−
00100 or equivalent
(b)
Install the drain union.
Torque: 29 N
×
m (291 kgf
×
cm, 21 ft
×
lbf)
HINT:
After applying the specified torque, if the drain pipe of the drain
union is not located as shown in the illustration, rotate the drain
union further clockwise so the drain pipe faces downward.
34.
INSTALL OIL CHECK VALVE SUB
−
ASSY
(a)
Using an 8 mm hexagon wrench, install a new gasket and
the check valve.
Torque: 33 N
×
m (331 kgf
×
cm, 24 ft
×
lbf)
35.
INSTALL ENGINE REAR OIL SEAL RETAINER
(a)
Apply seal packing to the oil seal retainer as shown in the
illustration.
Seal packing: Part No. 08826
−
00080 or equivalent
NOTICE:
S
Install a nozzle of which opening is cut to 2 to 4 mm
(0.08 to 0.16 in.).
S
The parts must be set within 3 minutes and must be
assembled within 15 minutes after applying seal
packing. Otherwise the material must be removed
and reapplied.
S
Immediately remove the nozzle from the tube, then re-
install the cap.
(b)
Install the oil seal retainer with the 6 bolts. Tighten the
bolts uniformly in several steps.
Torque: 7.4 N
×
m (75 kgf
×
cm, 65 in.
×
lbf)