A09512
Groove
A56048
A09497
A56046
A87946
Front Mark
(Arrow)
Front Mark
(Protrusion)
−
ENGINE MECHANICAL
CYLINDER BLOCK ASSY (1CD
−
FTV)(From September,
2003)
14
−
59
1CD
−
FTV ENGINE REPAIR MANUAL (RM1046E)
(c)
Install the 2 thrust washers on the No. 3 bearing cap with
the oil grooves facing outward.
(d)
Install the 5 main bearing caps in their proper locations.
HINT:
Each bearing cap has a number and font mark.
(e)
Apply a light coat of engine oil to the threads and under-
heads of the main bearing cap bolts.
(f)
Install and uniformly tighten the 10 bolts of the main bear-
ing cap in several steps.
Torque: 115 N
×
m (1,173 kgf
×
cm, 85 ft
×
lbf)
(g)
Check that the crankshaft turns smoothly.
28.
INSTALL W/PIN PISTON SUB
−
ASSY
(a)
Install a new snap ring on one side of the piston pin hole.
(b)
Gradually heat the piston up to approximately 60
_
C
(140
_
F).
(c)
Coat the piston pin and piston hole of the piston with en-
gine oil.
(d)
Align the front marks of the piston and connecting rod,
then push in the piston pin by hand.
(e)
Install a new snap ring on the other side of the piston pin
hole.