IN-3
INTRODUCTION - How to Use This Manual
The procedures are presented in a step-by-step format:
• The illustration shows what to do and whereto do it.
• The task heading tells what to do.
• The detailed text tells how to perform the task and gives other
information such as specifications and warnings.
Example:
This format provides the experienced technician with a
FAST TRACK to the information needed. The upper case
task heading can be read at a glance when necessary, and
the text below it provides detailed information. Important
specifications and warnings always stand out in bold type.
REFERENCES
References have been kept to a minimum. However, when they
are required, you are given the page to refer to.
SPECIFICATIONS
Specifications are presented in bold type throughout the text
where needed. You never have to leave the procedure to look up
your specifications. They are also found in Appendix A for quick
reference.
CAUTIONS, NOTICES, HINTS:
• CAUTIONS are presented in bold type, and indicate there is a
possibility of injury to you or other people.
• NOTICES are also presented in bold type, and indicate the
possibility of damage to the components being repaired.
• HINTS are separated from the text but do not appear in bold.
They provide additional information to help you efficiently
perform the repair.
Summary of Contents for 1HD-T
