EM095--01
A01392
A01274
(1)
(3)
(4)
(4)
(2)
A01273
(5)
(6)
Z15474
(1)
(2)
A01594
(3)
(4)
--
ENGINE MECHANICAL
CYLINDER HEAD (2RZ--FE)
EM--33
RE M O VAL
1. REMOVE PCV HOSES
2. RE MOVE IGNITION COILS
(a)
Disconnect the 2 connectors from the ignition coils.
(b)
Disconnect high--tension cords at rubber boot from the
cylinder head.
(c)
Disconnect the 4 high--tension cords from ignition coil.
(d)
Remove the 4 bolts and 2 ignition coils from the bracket.
Torque: 10 N
∙
m (100 kgf
∙
cm, 7 ft
∙
lbf)
HINT:
Arrange the ignition coils in correct order.
3 . DI S CO NNE CT E NG I NE WI RE
(a)
Remove the ignition coil bracket and ground.
(b)
Disconnect these connectors and clamps:
(1)
w/ A/C:
A/C compressor connector
(2)
Oil pressure sensor connector and clamp
(3)
Engine coolant sender gauge
connector
(4)
3 engine wire clamps and engine wire
(5)
ECT sensor connector
(6)
VSV connector for EGR
(c)
Disconnect the 4 engine wire clamps and engine wire.
(d)
Remove the engine wire braked from air intake chamber.
(e)
Disconnect these connectors:
(1)
Throttle position sensor connector
(2)
ISC valve connector
(3)
Crankshaft position sensor connector
(4)
Knock sensor connector
CLICK HERE TO VIEW CHAPTER INDEX
Pages From Supplement
3RZ-F,3RZ-FE
