Z10936
Cylinder Head Side
Air Intake Chamber Side
A01694
P04666
Free
P04667
Lock
EM--50
--
ENGINE MECHANICAL
CYLINDER HEAD (2RZ--FE)
24. INSPECT INTAKE MANIFOLD
Using a precision straight edge and thickness gauge, measure
the surface contacting the cylinder head and air intake chamber
for warpage.
Maximum warpage:
0.20 mm (0.0078 in.)
If warpage is greater than maximum, replace the manifold.
25. INSPECT EXHAUS T MANI FO LD
Using a precision straight edge and thickness gauge, measure
the surface contacting the cylinder head for warpage.
Maximum warpage:
0.50 mm (0.0197 in.)
If warpage is greater than maximum, replace the manifold.
26. INSPECT CHAI N T E NS I O NE R
(a)
Check that the plunger moves smoothly when the ratchet
pawl is raised with your finger.
(b)
Released the ratchet pawl and check that the plunger is
locked in place by the ratchet pawl and does not move
when pushed with your finger.
CLICK HERE TO VIEW CHAPTER INDEX
Pages From Supplement
3RZ-F,3RZ-FE
