A01421
Plug
A01422
S05040
Vinyl Bag
S05382
A01423
--
ELECTRONIC FUEL INJECTION
EFI SYSTEM
FI--3
6. FUEL SYSTEM
(a)
When disconnecting the high pressure fuel line, a large
amount of gasoline will spill out, so observe these proce-
dures:
(1)
Put a container under the connector.
(2)
Slowly loosen the connection.
(3)
Disconnect the connection.
(4)
Plug the connection with a rubber plug.
(5)
When the connector and the pipe are stuck, pinch
the retainer between the hands, push and pull the
connector to free to disconnect and pull it out. Do
not use any tool at this time.
(6)
Inspect if these is any dirt or the likes on the seal sur-
face of the disconnected pipe and clean it away.
(7)
Prevent the disconnected pipe and connector from
damagiing and mixing foreing objects by covering
them with a vinyl bag.
(8)
Do not reuse the retainer removed from the pipe.
(9)
Must use hands without using tools when to remove
the retainer from the pipe.
(10) Check if these is any damage or foreing objects on
the connected part of the pipe.
(11) Match the axis of the connector with axis of the pipe,
and push in the connector until retainer markes a
”click” sounnd. In case that the connections is tight,
apply little amount of new engine oil on the tip of the
pipe.
(12) After having finished the connection, check if the
pipe and the connector are securely connected by
pulling them.
(13) Check if these is any fuel leakage.
CLICK HERE TO VIEW CHAPTER INDEX
Pages From Supplement
3RZ-F,3RZ-FE
