Toyota 2000 Tundra Owner'S Manual Download

Page: 137 / 250

TUNDRA (34413U)

135

If “WAIT” appears on the display,

it indi-

cates  that  the  inside  of  the  player  unit
may  be  too  hot  due  to  the  very  high  ambi-
ent  temperature.  Remove  the  disc  or  mag-
azine  from  the  player  and  allow  the  player
to  cool  down.

If “Err 1” appears on the display,

indicates  the  disc  is  dirty,  damaged,  or  it
was  inserted  up- side  down.  Clean  the
disc  or  insert  it  correctly.

If “Err 2” appears on the display,

indicates no disc is loaded inside the
magazine. Insert a disc.

If “Err 3” or “Err 4” appears on the
display,

it indicates there is a trouble in-

side the system. Eject the disc or maga-
zine. Set the disc or magazine again.

If “OPEn” appears on the display,

indicates  the  compact  disc  auto  changer
lid  is  open.  Close  the  compact  disc  auto
changer  lid.

If the malfunction is not rectified,

take

your vehicle to your Toyota dealer.

DISC

By using this button, you can select a
disc you wish to listen to.

Push  either  side  of  the  button  until  the
number  of  the  disc  you  want  to  listen  to
appears  on  the  display.

Dolby

B NR

∗

If you are listening to a tape that was
recorded with Dolby

B Noise Reduction,

push  the  button  marked  with  the  double- D
symbol.  The  double- D  symbol  will  appear
on  the  display.  Push  the  button  again  to
turn  off  Dolby

B NR.

The  Dolby  NR  mode  reduces  tape  noise
by  about  10  dB.  For  best  sound  reproduc-
tion,  play  your  tapes  with  this  button  on
or  off  according  to  the  mode  used  for
recording  the  tape.

∗

: Dolby noise reduction manufactured under license from

Dolby Laboratories Licensing Corporation. “DOLBY” and the
double D symbol

are trademarks of Dolby Laboratories

Licensing Corporation.

FM1·2

Push  “FM1·2”  to  turn  on  the  radio  and
select  the  FM  band.  “FM1”  or  “FM2”  will
appear  on  the  display.  This  system  allows
you  to  set  twelve  FM  stations,  two  for
each  button.

If  the  audio  system  is  off,  you  can  turn
on  the  radio  by  pushing  “FM1·2”.  Also,
push  “FM1·2”  to  switch  from  cassette  or
compact  disc  operation  to  radio  operation.

LOAD

This  button  is  used  to  load  the  compact
discs  in  the  compact  disc  auto  changer
which  is  integrated  with  the  radio  and  cas-
sette  player.  This  compact  disc  auto
changer  can  store  up  to  6  discs.

The key must be in the “ACC” or “ON”
position.

Loading one compact disc only—

To  load  one  compact  disc  only,  quickly
push  and  release  the  button.  If  you  hold
the  button  too  long  (if  the  audio  system
is  on  at  this  time,  you  hear  a  beep.),  the
mechanism  will  change  to  the  mode  for
loading  multiple  compact  discs.  After
pushing  the  button,  insert  a  compact  disc.
At  this  time,  the  indicators  on  both  sides
of  the  slot  are  flashing.  After  the  disc  is
loaded,  the  shutter  of  the  slot  will  close
and  the  indicators  will  stop  flashing.

If no compact disc is inserted, the shutter
will close after 15 seconds.