CH-8
CHARGING SYSTEM — Alternator
2. REMOVE PULLEY, FAN AND DRIVE END FRAME
FROM ROTOR
(a)
Mount the rotor in a soft jaw vise.
(b)
Remove the pulley nut, spring washer, pulley and
fan.
h
(c)
Remove the spacer collar and drive end frame.
(d)
Remove the spacer ring and snap ring.
3. REMOVE RECTIFIER END FRAME
(a)
Remove the four nuts, condenser and two terminal
insulators.
(b)
Remove the rectifier end frame.
(c)
Remove the insulator washer from the rectifier
holder stud.
4. REMOVE IC REGULATOR
Hold the IC regulator terminal with needle-nose pliers,
and unsolder the terminals.
NOTICE: Protect the rectifiers from heat.
5. REMOVE RECTIFIER HOLDER
Hold the stator coil lead with needle-nose pliers, and
unsolder the leads.
NOTICE: Protect the rectifiers from heat.
Summary of Contents for 3F-E
Page 1: ...ProCarManuals com ...