7.
Care is required when pulling out and inserting wiring
connectors.
(a)
Release the lock and pull out the connector.
(b)
Fully insert the connector and check that it is locked.
8. When inspecting a connector with a volt/ohmmeter.
(a) Carefully take out the water-proofing rubber if it is
a water-proof type connector.
(b)
Insert the test probe into the connector from the
wiring side when checking continuity, amperage or
voltage.
(c)
Do not apply unnecessary force to the terminal.
(d)
After checking, install the water-proofing rubber on
the connector securely.
9.
Use SST for inspection or test of the injector, cold start
injector or its wiring connector.
SST 09842-30050 and 09842-30070
FI-6
EFI SYSTEM —
Inspection Precautions
Summary of Contents for 3F-E
Page 1: ...ProCarManuals com ...