12 INSTRUMENT
en‐41
12.1.12.3 Brake indicator
▪ The brake indicator lamp comes on
when the parking brake is applied. (It
goes off when the parking brake is re
leased.)
▪ If the warning remains on even after the
parking brake is released, ask the
Toyota dealer for an inspection.
CAUTION
•
Before starting the truck, always release the parking brake lever and check that the lamp
goes off.
12.1.13 Timing belt caution function
(Diesel engine models)
(1)
(2)
(1) Diagnosis indicator
(2) Hour meter
When the engine timing belt is used over
4000 hours, the combination meter indicates
that the timing belt needs to be replaced by
the following behavior:
▪
Diagnosis indicator
Illuminates con
tinuously after the key switch is turned
on.
▪
Hour meter
Displays "bELT" for 10
seconds after the key switch is turned
on.
Should the above conditions occur, park the
truck in a safe location, apply the parking
brake and contact the Toyota dealer immedi
ately.
CAUTION
•
Once the timing belt caution function is on, have the timing belt replaced by the Toyota
dealer immediately. Failure to do so could cause serious damage to the engine.
NOTICE
The diesel engine timing belt needs to be replaced after every 4000 hours of use. It also
needs to be replaced when the SAS/OPS controller or the combination meter is replaced .
12.2 Multifunction display (Option)
(2)
(1)
(3)
(4)
(5)
MODE
(1)
Multiple screen display area
(2)
Switch (a): Low speed setting switch/ Down switch
(3)
Switch (b): Mode select switch/ Left switch
(4)
Switch (c): Right switch
(5)
Switch (d): Meter mode select switch/ Enter switch
NOTICE
•
Always operate the switch panel when the truck is stopped.
•
Always press switches with your finger tips. If a sharp pointed tool is used, the switch may
be damaged.
12.2.1 Start screen
MODE
The start screen is displayed for 1 second
after the key switch is turned on.
12
Summary of Contents for 40--8FD35N
Page 92: ...19 TRUCK DIMENSIONS en 93 19...
