Product details
Product guide – BT Levio W-series
31
Driving features/programming the truck
The LWE trucks are highly manoeuvrable and offer indi-
vidual setting options for the operators. Settings that the
operator can change himself are called operator parame-
ters. The trucks also have a machine register in which set-
tings only can be changed by a service technician. Please
refer to the service manual for detailed information. Upon
delivery from the factory, the trucks are preprogrammed
with three different parameter settings. When switched on
with PIN 1, the truck offers optimal parameter settings
for this truck type, with PIN2 it is switched on in a slower
mode and with PIN 3 truck characteristics are set to maxi-
mum performance. See all parameters in the parameter
table.
Automatic back-up
All parameters are stored in the logic card and the motor controller.
Feature
Each time a parameter is changed, the system automatically backs up the data. This
takes approx. 3-5 seconds during which time log-out is impossible. If, for example,
the handle in which the logic card is housed needs to be replaced, then the service
technician will be asked whether the parameters stored in the motor controller or
the logic card should be stored in the new handle. If the technician in this case se-
lects the motor controller, then all existing truck settings will be stored in the new
handle.
Benefit
Whenever a component needs replacement, current settings will not be lost. Apart
from the operator and service parameters, this also applies to the hour counters.
Summary of Contents for BT Levio LWE140
