FIG.3
FIG.4
4-16. Thread wiper motor
[Removal]
(1)
Remove the each setting screws (a)
and the change cover, the relay circuit
board cover, the thread stand plate,
the bobbin base and the rear cover.
(Fig.1)
(2)
Cut a cable tie and remove the relay
connector.
(3)
Remove the setting screw (b) and two
setting screws (c), and the thread
wiper motor. (Fig.1)
(4)
Remove the setting screw (d) and (e),
and the upper thread hook lever.
(Fig.3)
(5)
Remove the three setting screws (f)
and the motor base.(Fig.3)
Note: Be sure to insert the small
washer that is contained in each
setting screws of (3) and (4) sections.
Y motor bracket
(h)
[Installation]
Y motor
(1)
Attached in the reverse procedure of
removal
Note: Set the vertical position of the
upper thread hook lever slightly
upward, and make sure that the
connecting rod plate has a little play.
(2)
After attaching, check the distance A
from the needle center to the thread
wiper hook tip. [Please refer to 『“ 3-6
Position of the thread wiper hook.” 』
on page 28 ]
(3)
If the distance A differs from that
specified, loosen two setting screw (c)
and adjust by moving the thread wiper
motor base up/down.
4.REPLACEMENT OF MAIN COMPONENTS
Change cover
Relay circuit
board cover
(a)
(a)
(a)
(a)
-55-
Thread stand
plate
Bobbin winder
base
Rear cover
Summary of Contents for ESP9000
