4.REPLACEMENT OF MAIN COMPONENTS
4-17. Thread sensor
[Removal]
(1)
Remove the two each setting screws
(a), then remove the change cover and
relay circuit board cover. (Fig.1)
(2)
Remove the connector CN2.
(3)
Remove the tension base cover.
(Fig.1)
(4)
Raised the connector upwards and
disconnect it.
(5)
Cut the cable tie, remove the two
setting screws (b) then remove the
sensor arm. (Fig.4)
(6)
Extract the thread sensor base from
the thread sensor rail; remove the
setting screw (c) and the thread
sensor board. (Figs.3, 4)
[Installation]
(1)
Attach the sensor board with the
setting screw (c). (Fig. 4)
(2)
Put the code of thread sensor base
upwards into the thread sensor rail.
(Fig. 3)
(3)
Putting a sensor arm into the slot of
the thread sensor base and secure it
with two setting screws (b). (Fig.2)
Note: At this time, check the sensor
position.
[Please refer to 『 “ 3-11. Thread
sensor” 』 on page 34]
(4)
Secure the cord with a cable tie and
insert the connector.
Note: The blue field of a code is
turned and inserted in a spool side. At
this time, check the connector
connection by pulling a code with
hand.
(5)
Mount the relay circuit board cover,
change cover and tension base cover.
Tension base cover
(a)
Change
cover
Relay circuit board cover
FIG.1
FIG.2
(b)
Sensor arm
Thread sensor rail
Thread sensor base
FIG.3
(c)
Sensor board
FIG.4
-57-
Summary of Contents for ESP9000
