2.TROUBLESHOOTING
Preliminary inspection
・ Initialize of LCD display may be OFF when
turn the power on.
2-6 Holder does not return
to stroke center after
home position return.
Item
Method
Standard Action
X.Y holder
position
check
The distances X,, set the joint plate at the
original position (X0, Y0) and check the
distances from the surface of the detecting
plate to the center of the photo-sensor.
The distances Y, set the X holder to its
forefront position by pressing the emergency
stop button, and check the distances from
the surface of the detecting plate to the center
of the photo-sensor.
X=65.7
±1mm
Y=213.5
±1mm
(Position
of
cap
frame
sensor is
Y=133.5
±1mm)
C=1±
0.5mm
Adjust
See
P.32.
Connection
of sensor
connector
Must be
connecte
d
correctly.
Connect
correctly.
Output
voltage
Turn the power on and check
voltage across ⑤(green)and ⑥
(blue) with a circuit tester.
When
obstructed:
3.5~5V
When not
obstructed:
0~0.8V
Replace.
X Y motor
Limit sensor
X Y holder
Operation panel
Slit
Joint plate
Photo-sensor
X holder
-12-
Summary of Contents for ESP9000
