Thread
cutter
evenness
Smear the
thread
catcher with
a felt pen,
and check if
the thread
cutter makes
contact
evenly.
Must be
contact
evenly.
Adjust.
See
P.25.
Blade
pressure
B=2
~
3mm
(0.6
~
1.5kg・
㎝)
Adjust.
See
P.25.
2.TROUBLESHOOTING
・ The needle or bobbin thread tension may be
too tight.
・ The needle and thread may be too thick for
the cloth.
・ The cloth tension may be too loose.
・ The needle tip may be blunt.
・ The hole in the needle plate may be burred.
・ The needle thread may be stuck around the
threading tube holder and the thread take-up
lever.
Item
Method
Standard Action
Thread take
-up spring
stroke (A)
Hold the thread before the needle
roller. Pull the thread downward and
the thread take-up spring starts
moving. Check the length of thread
pulled until the spring stops.
A=20±
1mm
Move the
retracting
lever
position
up and
down to
adjust.
Lower cover
Retracting Lever
(Equivalent to 8 teeth of ratchet)
Needle Roller
Thread Take-up
Spring
Thread tension
Thread tension
Hook support
Preliminary inspection
2-14 Puckering
-17-
Summary of Contents for ESP9000
