16
ENGLISH
,
4. Make sure the position of the heater is level by using the plumb bob located at the right side of the heater. The
plumb bob weight should be within the circle. If the plumb bob weight is not within the circle, adjust the heater
legs until the plumb bob weight is within the red circle.
Plumb bob as viewed from above
Good
Bad
Circle
Weight
5. A room temperature sensor is provided with approx. 2.5 meters long extension wire. It
is located on the rear of the cabinet. Make sure that the extension wire is not touching
the exhaust pipe. The room temperature sensor can be installed with a wood screw.
Screw down the wood screw provided with the heater into the desired location on the
wall. Hook the back of the room temperature sensor.
NOTE: Choose a location for the sensor that is not in the path of direct sunlight, drafts
or the flow of warm air from the heater.
6. THE HANDLE FOR OVEN (only for FQ-C70)
Use the handle for oven to open and close the oven as it will be hot during the operation. When you do not use
the handle for oven, hang it on the hole on the right side panel.
CAUTION:
DO NOT touch directly as the oven will be hot.
Handle
for oven
Read installation manual before installing heater.
