ENGLISH
,
5
SECTION E:
OPERATION
BEFORE IGNITION
1. FILLING FUEL
Fill the external tank using a fuel pump and clean off any spilled fuel.
When there is not enough fuel in the tank, the heater will extinguish automatically.
When this occurs, you will hear the buzzer and
E-2
or
E-6
is displayed.
2. OPEN THE VALVE(S)
Open the valve(s) of the external fuel tank.
3. START THE FUEL FLOW
If using heater for the first time, press the red reset button in order to send fuel to the
fuel sump and release.
NOTE: Make sure there is no fuel leakage from the fuel line or joints.
Also make sure fuel tank is not too high. See installation instructions.
4. CONNECT THE HEATER
Connect heater into a proper electrical outlet. (refer to SECTION A). On digital indicator
pre-set “Two Dashes” will be showing.
NOTE: Do not connect to an outlet shared with other appliances.
5. SET CLOCK
IMPORTANT:
The clock on the heater must always be set to the correct time.
It is only possible to set the correct time, when the heater is connected
to the mains and not burning.
Use the adjustment keys to set the time.
First press either of the two keys to switch
(the CLOCK lamp and the information
display will start blinking). Next, set the hours using the key on the left (-HOUR) and the
minutes using the key on the right (+MIN.). After approximately 10 seconds the blinking
will stop and the setting will be locked. After switching off the heater, the clock time will
be displayed.
OPERATION
1. TURNING HEATER ON
1. Press ON/OFF button to “ON” position. You will hear the buzzer and the ON/OFF
button will be blinking. The current room temperature and the set temperature will
be shown on the digital indicator. TEMP. lamp will be lit and then blower motor and
ignition will start. ON/OFF switch will continue to blink during the preheating time.
2. After approx. 2 – 6 minutes ignition will take place. (*) After ignition, ON/OFF switch
will change blinking to continuous. Circulation fan will turn on approx. 2minutes after
ignition.
NOTE: (*) Pre -heating depends on the room temperature.
Room temperature:
under 0˚C 6
minutes
0˚C - 15˚C 4
minutes
15˚C 2 minutes
When room temperature is lower than 0°C, ignition will take place after 7 minutes.
Red Reset Button
