Connect the Hardware
If your internet connection is through an Ethernet cable from the wall instead
of through a DSL / Cable / Satellite modem, connect the Ethernet cable
directly to the router’s Internet port, then follow steps 1, 5 and 6 to complete
the hardware connection.
Modem
Power adapter
Turn off the modem,
and remove the backup
battery if it has one.
2
3
Connect the modem to the
router’s Internet port with an
Ethernet cable.
Turn on the modem, and
then wait about
2 minutes
for it to restart.
4
Internet
Quick Installation Guide
Images may differ from actual products.
Power
adapter
Router
1
Install the antennas.
Connect the power
adapter to the router
and turn on the router.
5
Verify that the following LEDs turn solid before
continuing with the configuration.
6
Note: If the 2.4GHz LED and 5GHz LED are off, please press the
Wi-Fi On/Off button on the side panel for 2 seconds, then both LEDs
should turn stable in a few seconds.
For optimum performance, orient the four antennas
as shown in the drawing below.
Power
On
On
Internet
5GHz
On
2.4GHz
On
30°
30°
Wi-Fi Router
