T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
149
Parameter
dhcp
—— Specify the Layer 3 interface to obtain IP address from the DHCP
Server.
bootp
—— Specify the Layer 3 interface to obtain IP address from the BOOTP
Server.
Command Mode
Interface Configuration Mode
Example
Enable the DHCP Client function on the Lay 3 routed port 1/0/1:
T2700G-28TQ(config)# interface gigabitEthernet
1/0/1
T2700G-28TQ(config-if)# no switchport
T2700G-28TQ(config-if)# ip address-alloc dhcp
Disable the IP address obtaining function on the VLAN interface 2:
T2700G-28TQ(config)# interface vlan
2
T2700G-28TQ(config-if)# no ip address
reset
Description
The
reset
command is used to reset the switch’s software. After resetting, all
configuration of the switch will restore to the factory defaults and your current
settings will be lost.
Syntax
reset
[
unitid
]
Parameter
unitid
—— Specify the unit in the stack to reset its software. If not specified, all
members software in the stack will be reset.
Command Mode
Privileged EXEC Mode
Example
Reset the software of all the members in the stack:
T2700G-28TQ#reset