T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
179
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet /
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Enable the broadcast control function for Gigabit Ethernet port 1/0/5 and set the
bandwidth for receiving broadcast packets as 256 kbps:
T2700G-28TQ(config)#interface gigabitEthernet
1/0/5
T2700G-28TQ(config-if)#storm-control broadcast
256
storm-control multicast
Description
The
storm-control multicast
command is used to enable the multicast control
function. To disable the multicast control function, please use
no storm-control
multicast
command. Multicast control function allows the switch to filter
multicast in the network. If the transmission rate of the multicast packets
exceeds the set bandwidth, the packets will be automatically discarded to avoid
network broadcast storm.
Syntax
storm-control
multicast
rate
no storm-control multicast
Parameter
rate
—— Select the bandwidth for receiving multicast packets on the port. The
packet traffic exceeding the bandwidth will be discarded. Range: 1 to 1000000
kbps for the gigabit port, 1 to 10000000 kbps for the ten-gigabit port.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet /
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)