T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
181
bandwidth
Description
The
bandwidth
command is used to configure the bandwidth limit for an
Ethernet port. To disable the bandwidth limit, please use
no bandwidth
command.
Syntax
bandwidth
{ [
ingress
ingress-rate
] [
egress
egress-rate
] }
no bandwidth
{ all | ingress | egress }
Parameter
ingress-rate
——Specify the bandwidth for receiving packets. Range: 1-100000
kbps for the megaport, 1-1000000 kbps for the gigaport, 1 to 10000000 kbps for
the ten-gigabit port.
egress-rate
—— Specify the bandwidth for sending packets. Range:1-100000
kbps for the megaport, 1-1000000 kbps for the gigaport, 1 to 10000000 kbps for
the ten-gigabit port.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet /
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Configure the ingress-rate as 5120kbps and egress-rate as 1024kbps for
Gigabit Ethernet port 5:
T2700G-28TQ(config)#interface gigabitEthernet
1/0/5
T2700G-28TQ(config-if)#bandwidth ingress
5120
egress
1024
clear counters
Description
The
clear counters
command is used to clear the statistic information of all the
Ethernet ports.