T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
372
T2700G-28TQ(config)# router ospf
1
T2700G-28TQ(config-router)# distance
100
timers throttle spf
Description
The
timers throttle spf
command is used to configure the computing delay and
interval of the SPF, thus preventing the consumption of the CPU and memory
caused by frequent SPF computing. To restore to the default value, please use
the
no timers throttle spf
command.
Syntax
timers throttle spf
spf-delay spf-holdtime
no timers throttle spf
Parameter
spf-delay
—— The delay time of the SPF computing, ranging from 1 to 600
seconds. The default value is 5 seconds.
spf-holdtime
—— The minimum interval between two SPF computings, ranging
from 1 to 600 seconds. The default value is 5 seconds.
Command Mode
Router Configuration Mode
Example
Configure the computing delay and interval of the SPF as 10 seconds:
T2700G-28TQ(config)# router ospf
1
T2700G-28TQ(config-router)# timers throttle spf
10 10
timers lsa arrival
Description
The
timers lsa arrival
command is used to configure the minimum interval time
of the same LSA instances. The same LSA instances will be discarded without
acknowledgement if their actual arriving interval is smaller than the configured
interval. To restore to the default value, please use the
no timers lsa arrival
command.