1.1 Wall Mounting Preparation
Before mounting the switch, you need to prepare the tools below:
Ǵ
A screw driver.
Ǵ
Two screws which complies to the corresponding standard. For details, see
1.2 Wall Mounting Procedure
On the bottom of the panel, there are two mounting holes. You need to drive two screws
into the wall, then mount the switch on the wall. Note that the switch should be mounted
on the wall upright rather than sideways.
1) Determine the location on the wall where you want to mount the switch.
2) Mark the wall where the two mounting holes are. The distance between the two marks
must be the same as that between the two mounting holes of the switch. For the wall-
mounting-holes distance, see
.
3) Drive the screws into the wall at the marks using the screw driver. For the Screw-
Head-to-Wall Minimum Distance, see
.
4) Mount the switch on the wall.
1.3 Wall Mounting Specification
Model
Screw Standard of
ANSI B1.1
Minimum Length
of Screw
Screw-Head-to-Wall
Minimum Distance
Wall-Mounting-Holes
Distance
LS105G
4#, (5#), 6#
7mm
1.5mm
76mm
LS108G
4#, (5#), 6#
7mm
1.5mm
65mm
LS1005G
4#, (5#), 6#
7mm
1.5mm
38mm
LS1008G
4#, (5#), 6#
7mm
1.5mm
48mm
TL-SF1005LP
4#, (5#), 6#, 8#
8.5mm
1.5mm
39mm
TL-SF1005P
4#, (5#), 6#, 8#
8.5mm
1.5mm
39mm
TL-SF1006P
4#, (5#), 6#, 8#
8.5mm
1.5mm
94mm
TL-SF1008LP
4#, (5#), 6#, 8#
8.5mm
1.5mm
105mm
TL-SF1008P
4#, (5#), 6#, 8#
8.5mm
1.5mm
105mm
TL-SF1009P
4#, (5#), 6#, 8#
8.5mm
1.5mm
105mm
TL-SF1016D
4#, (5#), 6#
8.5mm
1.5mm
157.2mm
TL-SG1005LP
4#, (5#), 6#, 8#
8.5mm
1.5mm
39mm
TL-SG1005P
4#, (5#), 6#, 8#
8.5mm
1.5mm
39mm
TL-SG1008D
4#
8mm
2mm
100mm
